What Do You Need To Know About Tire Change Wisconsin?

For all drivers, you know how tire change Wisconsin is a must-have skill. If you rely on a cell phone to save you in an emergency on the road, there is always the probability that you’ll forget to charge it, that it’ll be out of range, or that you’ll leave it at home. Flat tires may happen anytime, and learning how to repair flat tire is not something you can learn on your phone.

Thankfully, replacing a tire isn’t tricky. Follow the steps below to be prepared in the event of a flat.

How Do You Change Tires?

The steps to know about change tires

Locate Yourself In A Safe Place

Do not quickly break or turn when you realize you have a flat tire. Reduce your speed gradually and check the area for a level, straight length of road with a wide shoulder. A parking lot that isn’t full would be perfect. It’s preferable to have level ground because it will keep your vehicle from rolling. Furthermore, straight road sections are preferable to curves since oncoming traffic is more likely to notice you.

Moreover, never try to replace a tire near incoming traffic on a small shoulder. Continue to move (slowly) until you reach a safer location. While driving with a flat tire may damage your rim, it is preferable to be hit by an inattentive vehicle.

Always refer to your owner’s manual for precise instructions on how to change a flat tire on your vehicle.

Activate Your Hazard Lights

Other cars will be able to notify you on the side of the road thanks to your danger lights or “flashers.” Turn them on as soon as you think you need to pull over to avoid an accident.

Use Your Parking Brakes

When preparing to replace a flat tire, always use the parking brake once you’ve reached a complete stop. Will reduce the probability of your vehicle rolling.

Wheel Wedges Apply

Wheel wedges are placed in front of or behind the tires to keep the vehicle from rolling while you work on the flat tire. Place these in front of the ts if you’re changing a rear tire. Put the wheel wedges at the back rear tires if your flat tire is on the show.

As well as “real” wheel wedges, bricks, or heavy stones can suffice. Make sure they’re big enough to keep the car from rolling away.

Must Remove Hubcap Or Wheel Cover

If a hubcap covers your car’s lug nuts, removing the hubcap before using the jack to lift the vehicle is more accessible. If your lug nuts are visible, you can skip this step.

Lug Nuts Are To Be Loosened

Rotate the lug nuts counterclockwise with the lug wrench till they are no longer resistant. It’s okay if you have to use force. If required, use your foot or your entire body weight.

Loosen the lug nuts by about 14 to 12 turns, but don’t entirely remove them yet. That’ll come in handy when it’s time to take your tire/wheel off the vehicle.

Should Place The Jack Under The Vehicle

The best location for the jack is usually beneath the car frame, next to the flat tire. Many car frames have molded plastic on the bottom with a cleared area of exposed metal for the jack.

Use The Jack To Raise The Vehicle

Before attempting to elevate your vehicle, insert a shortcut of 2×6″ wood beneath the jack to keep it from settling under the weight of your car and becoming unbalanced. On asphalt, this strategy is beneficial for Tire Change Wisconsin.

Moreover, raise the car with the jack until the flat tire is roughly six inches above the ground.

Disconnect The Lug Nuts

It’s now time to remove the lug nuts altogether. You should be able to unscrew them mostly by hand now that you’ve already loosened them.

Remove The Flat Tire

Pull the tire gently toward you, gripping the treads until it is entirely free of the hub behind it. Place it on its side to prevent it from rolling away.

Install The Secondary Tire On The Lug Bolts

Place the spare on the hub by matching up the lug bolts with the rim. Gently push until the lug bolts are visible through the edge.

Leave a Reply

Your email address will not be published. Required fields are marked *