Plumber near me are more common in the toilet as it is where the most common problems occur. While it is recommended that you call your reliable local plumber immediately, but here are some instances where a certain problem is easy enough for you to fix. Here are some of the most common problems in the toilet and how you can fix them.
Once you find it difficult to flush, it could either be the water supply is limited or there is no water at all, or there a certain blockage in the flush tank obstructing the flow of the water. If the case is the latter, you can replace the valve yourself. This can be easily bought in your local hardware or plumbing supplies. Over time, the valve wears out and might need replacement. It is also essential to tighten the handle as it could also be the case.
There are times when the lever or the flush ball has worn out and will cause your tank to overflow. You will notice this because the water continues to flow after you have released the handle or if you still hear water flowing even after flushing. It could also be that the refill valve is trapped with dirt or damaged.
The Non-stop water flow is a different case. You can fix this by moving the float ball as it might probably be sitting too high. Intake assembly toilets has clips attached to the rod, these need to be adjusted to lower the water level.
If you could feel that your tank is leaking. Clean and dry the floor area in the toilet. Once done, put several drops of food color in the bowl and leave it for a few minutes. Check if there is colored water the dry floor earlier. If you notice streaks of colored water then your toilet is probably leaking. Check the wax ring as it might have dislodged. See if there are loose bolts, tighten them up. In the case that the tank is really cracked, then a replacement is needed.
Sometimes there are occurrences of flush and handle valve. The solution to this is to reposition the flush ball once again. A flush ball sitting too high could cause the water leaks to happen. In the event that a broken valve is causing the problem, might as well replace it.
This is a common scenario during cold weather. Your local hardware store sells insulation for tanks that is quite easy to install.